- Designed Wire Harness for High Speed data Connector Cable
- Conducted Feasibility study, DFA/DFM and turned the voice of the customer to Product Specification
- Performed Design and Process FMEA
- Conducted DOE on the Crimping Process to determine the Optimum Crimp Height to Crimp Width Specification
- Conducted Reliability testing to insure Quality and Safety compliance
Parts and Process:
1. Contact Pin: Stamping Process(Press) and Plating
2. Housing: Molding Process
3. Shell: Die Casting Process
4. ReelPacking parts: Emboss Tape Molding
- High Speed Data Transmission for Automotive Navigation and infotainment
- Advance Driver Assistance System(ADAS)
Electrical Specification
- Conductivity Test
- Insulation test
- Resistance Check Test
Mechanical Specification
- Conductivity Test
- Insulation test
- Resistance Check Test
Special Specification
- Impedance Checking
- Aging Test
- Temperature Cycle Test(Heat Shock)
- Vibration Test
- Design Product based on USCAR requirements and Customer Specific Requirements while cascading it to each parts.
- Conduct DFM/DFA of each designed Product
- Perform Design and Process FMEA
